Marlin становится на паузу при печати с SD карты

Принтер creativity ELF

плата MKS Robin Nano v1.2

прошивка marlin  2.0.6

один и тот же gcod 

через octoprint печатает

с SD карты встает на паузу после прогрева hotend

В чем может быть проблема??

вот сам код

; generated by PrusaSlicer 2.2.0+linux-x64 on 2020-09-08 at 09:44:59 UTC

; 

; external perimeters extrusion width = 0.62mm

; perimeters extrusion width = 0.62mm

; infill extrusion width = 0.62mm

; solid infill extrusion width = 0.62mm

; top infill extrusion width = 0.62mm

M201 X1000 Y1000 Z40 E100 ; sets maximum accelerations, mm/sec^2

M203 X200 Y200 Z10 E60 ; sets maximum feedrates, mm/sec

M204 P500 R500 T500 ; sets acceleration (P, T) and retract acceleration (R), mm/sec^2

M205 X20.00 Y20.00 Z0.40 E2.50 ; sets the jerk limits, mm/sec

M205 S0 T0 ; sets the minimum extruding and travel feed rate, mm/sec

M107 ; disable fan

M190 S80 ; set bed temperature and wait for it to be reached

M104 S250 ; set temperature

G28 ; home all axes with heated bed

;M205 J0.01 Diviation

; end of start.gcode

M109 S250 ; set temperature and wait for it to be reached

G21 ; set units to millimeters

G90 ; use absolute coordinates

M82 ; use absolute distances for extrusion

G92 E0 ; reset extrusion distance

; Filament gcode

; Linear Advance set K factor

;М900 К0.1

G1 F1200.000

G1 X305.234 Y287.326

G1 X305.063 Y289.043 

G1 X304.639 Y290.724 

G1 X303.977 Y292.317 

G1 X303.088 Y293.796 

G1 X301.904 Y295.220 

G1 X294.299 Y302.805