смузи и corexy

Доброго времени. При попытке движения X или Y, каретки движется по диагонали, вместо движения по оси.

Плата mks 1.3

концевики механические, подлючены в минимум

# Endstops

endstops_enable true # the endstop module is enabled by default and can be disabled here

corexy_homing true # set to true if homing on a hbit or corexy

alpha_min_endstop 1.24^! # add a ! to invert if endstop is NO connected to ground

alpha_max_endstop nc # NOTE set to nc if this is not installed

alpha_homing_direction home_to_min # or set to home_to_max and set alpha_max

alpha_min 0 # this gets loaded after homing when home_to_min is set

alpha_max 400 # this gets loaded after homing when home_to_max is set

beta_min_endstop 1.26^! #

beta_max_endstop nc #

beta_homing_direction home_to_min #

beta_min 0 #

beta_max 400 #

gamma_min_endstop 1.28^! #

gamma_max_endstop nc #

gamma_homing_direction home_to_min #

gamma_min 0 #

gamma_max 400 #

Принтер большой)